drylin® R aluminium shaft as tube, AWMR

1 from 2

Particularly lightweight
Optimal in combination with iglidur® J/J200 liners
Low wear of plain bearings
Corrosion-resistant
Aluminium EN AW 6060/6061 (ALU)

Part No.

AWMR-12

Outer diameter d [mm]

Design

drylin® R AWMR aluminium hollow shaft is made from EN AW 6061/6060. It is hard anodised with a rigidity of up to 550HV. Due to the technical surface treatment, slight colour deviations may occur between the shafts. This shaft is cut with a tolerance of ±1mm unless otherwise specified. Customised tolerances are available upon request. Our iglidur J and J200 plain bearings are the best match for our anodised aluminium shafts. A160 and E7 can also be used on this shaft material while our X liners should be avoided.

Certificates and standards